The project is waste water treatment plant....Its cost was 40 million usd  i was the struvtural design eng. And prepsring the shop drawings and as built drawings.....etc

Category: Engineering & Manufacturing
Subcategory: CAD drawing
What do you need?: Create a new file from scratch
Is this a project or a position?: Project
Required availability: As needed

I will submit my dwg already with the floor plan created and one elevation. I would need 3 other elevations, two sections and the Axonometric (45-45) view of the entire structure. I need the same amount of detail as in the elevation that is already completed

Category: Engineering & Manufacturing
Subcategory: CAD drawing
What do you need?: Modify or edit an existing file
Is this a project or a position?: Project
Required availability: As needed

Educational center of 9 floors and 1 half-basement
engineering review structure, architecture, sanitary, electrical.
Compatibilization of several disciplines.
Seismic building

Category: Engineering & Manufacturing
Subcategory: CAD drawing
What do you need?: Create a new file from a sketch or another format
Is this a project or a position?: Project
Required availability: As needed

My project is about designing a highway. I also need to draw channel and drainage system with Civil 3D software....................

Category: Engineering & Manufacturing
Subcategory: CAD drawing

My project is to design a highway. I need to draw the drainage system with Civil 3D software............................................

Category: Engineering & Manufacturing
Subcategory: CAD drawing
What do you need?: Modify or edit an existing file
Is this a project or a position?: Project
Required availability: As needed

It is my final year project. The single line diagram I've given in the document is just an idea. I have to design it in Matlab and demonstrate the design to my supervisor that the microgrid can operate while connected to the grid or disconnected from the grid.
I have to show voltage stability analysis to show the microgrids is not overvoltage or undervoltage. The parameter value on each model may be inaccurate as it is only an estimation. I also need teaching and guidance on how to demonstrate the results to my supervisor.

Category: Engineering & Manufacturing
Subcategory: CAD drawing
What do you need?: Create a new file from a sketch or another format
Is this a project or a position?: Project
Required availability: As needed

I am looking for a CAD Designer to do freelance on a product drawing. Drawing will be a new type of makeshift foldable stall made from aluminum.

Category: Engineering & Manufacturing
Subcategory: CAD drawing
What do you need?: Create a new file from scratch
Is this a project or a position?: Project
Required availability: As needed